MFx Explosionproof Melt Pressure Transmitter - 2-wire 4-20 mA
Data SheetAvailable Configuration:
The entire amplifier/sensor assembly of an MF Series Melt Pressure Transmitter is packaged in a stainless steel welded enclosure with a conduit cable fitting. This metal enclosure is completely sealed from the atmosphere, and is approved to meet hazardous area requirements. The MF converts applied pressure at the point of measurement to a proportional voltage output signal. An amplifier converts the strain gage signal to a 4-20 mA output. The small capillary tube filled with a special medium isolates the amplifier from potential thermal damage.
- Factory Mutual approved Explosionproof for Class I,
Division 1, Groups A, B, C, D, and Dust-Ignitionproof for
Class II, Division 1, Groups E, F, G - Other approvals: CE, NEMA 4/IP65
- High-level output 2-wire, 4-20 mA
- Accuracy: <±0.25% FSO (H); <±0.5% FSO (M)
- Internally generated 80% calibration signal (R-Cal)
- 1/2-20 UNF thread standard, M18x1.5 also available
- Fluid-filled system for temperature stability
- 15-5 PH stainless steel diaphragm with Armoloy coating
standard (others available on request) - 17-7 PH corrugated diaphragm with TiN (Titanium
Nitride) coating for ranges below 100 bar (1500 psi)
